[. . . ] It is very important that this feature be disabled, particularly if you will be using the FAT32 file system. Instructions for disabling "Save-to-Disk" are in the section below labeled, "Disabling the Save-to-Disk in the BIOS Setup. " Updated utilities will be distributed at a later time to remedy this. Note: To identify your computer's file system, double click on the "My Computer" desktop icon. If the system is running FAT32, it is listed here next to "File system. " If it is FAT16, FAT or FAT 16 appears. CAUTION Converting your hard drive to the FAT32 file system format significantly enhances file operations and save disk space. [. . . ] Press the down arrow key to the "Auto Save To File" row entry. Press the down arrow key to select the "Disable" setting if the "Enable" setting is currently set. 2 NEC Versa 2200 Windows 98 Upgrade Important Information 9. Press the Enter key to return to the "Power Management Options" menu. Press the down arrow key to select "Exit and Save Changes. " 13. Press the Enter key twice to reboot the system. Upgrading To Windows 98 Follow these steps to upgrade from Windows 95 to Windows 98. Insert the Windows 98 installation CD into your system's CD-ROM drive. If your system has Auto Insert Notification enabled, you will see a Windows 98 graphic asking you if you want to upgrade to Windows 98. (Your CD-ROM drive will most likely be E:. ) Double click on the SETUP icon to start the Setup Wizard. The Setup Wizard guides you through the installation process, asking you for information when necessary. Note: You must make three key decisions depending on your particular needs and system configuration. Use the following guidelines. T Concerning docking stations: You should perform the Windows 98 upgrade in the mode (docked or undocked) which you use most often. This is purely a decision of convenience, as Windows 98 upgrades docking configurations on an "as detected" basis. During the Windows 98 upgrade process, you are prompted to back up your Windows 95 system files. Backing up your Windows 95 systems files allows you to later uninstall Windows 98, however it requires an additional 50 MB of disk space. These backup files can be removed later through the Add/Remove Programs icon in Control Panel. During the Windows 98 upgrade process you are prompted to make a Windows 98 bootable Startup diskette, which contains generic drivers to start your system in case of disaster. If your system cannot run both a floppy drive and a CD-ROM drive at the same time, skip this section by selecting "Cancel" at the "Insert diskette" screen. [. . . ] Confirm or correct the source file path (normally "A:\"), then click OK. The Select Driver window displays NEC VersaGlide. 4 NEC Versa 2200 Windows 98 Upgrade Important Information 5. Click NEC VersaGlide, then click OK to copy the driver files to your system. [. . . ]